![]() ![]() Message is displayed whenever a VLAN interface is newly created, so Trunk or the VLAN ID that is configured for an access port. Is associated with the data frames on an ISL or 802.1Q-encapsulated The vlan_id value corresponds to the VLAN tag that The SVIs are created the first time that youĮnter the interface vlan vlan_id command for a particular VLAN. Support for extended addressing was added. Space between the first port and the hyphen (-): When you define a range, you must enter a Single command separate each range with a comma. You can define up to five port ranges on a Type, and the ports within a range cannot span the modules. A port range must consist of the same port ![]() You can either specify the ports or the name You can enter the port range in two ways: ![]() With the interface range command do not get Port range are saved to NVRAM, but the port ranges that are created Range using the define interface-range command.Īll configuration changes that are made to a Interface range command are applied to all theīefore you can use a macro, you must define a The VLANs that are notĭisplayed cannot be used in the interface range command. To display the VLAN SVIs, enter the show running config command. You can use the interface range command on the existing VLAN SVIs only. Support for extended VLAN addresses added. Support for this command was introduced on ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |